The ‘Fast’ method allows the user to show all of the faces that are different between the two models to within a single tolerance. There are two methods of display for the new ‘comparison’ module. Switch ON both the “Part 1” and “Part 2” layer to show both models together.Īnalysis > Compare Select the first body - Select PART 1 ( the original GREEN solid model ) Select the body to compare - Select PART 2 (the second ORANGE solid model ) NOTE : The comparison tolerance value can be changed from inside the compare control panel.Ī new interface will be displayed (shown below) We will use the VISI-Comparison module to check for the model differences between Part 1 and Part 2. The second model represents a second revision of the same component. There will be a second ORANGE model that resides on the “Part 2” layer. Part 1 is to be used as the first revision of a plastic component. The GREEN model will reside on the “Part 1” layer.
Start by opening the workfile: File > Open
Object The following example will highlight some of the required techniques to fully utilise the dedicated analysis functions within VISI-Modelling. During this exercise, it is assumed that the user has a basic knowledge of the VISI-Series software. INTRODUCTION Pre-requisite It is important that before you attempt this VISI-Analysis training example you must have completed and fully understood the previous VISI-Design and VISI-Modelling and VISISurface Modelling examples.
0 kommentar(er)
